AIR PORT AND BE COOL Window Ventproduct shot
call 1-866-274-3701product shot 2

sales@canadiangreenproducts.ca

AIR PORT™ is designed to channel air into moving vehicles only, but not when a vehicle is stationary.
AIR PORT™ funnels air into moving vehicle at speed of vehicle travel.

Because of air speed directed into the vehicle, the incoming air is very cool and or cold. This cools the inside of the vehicle making the AIR PORT™ a very effective way to keep cool while driving, and reduces reliance on gas-consuming air conditioning.

VEHICLE SPEED

SPEED OF INCOMING AIR WITH AIR PORT™ COLD AIR VENT
60 mph approx. 55-60 mph
100 km approx. 90-100 km

PARTS

1. base
2. angle connector
3. blade
4. screws & nuts
5. safety cord

figure 1 Left Side Assembly


Placement Locations

LEFT SIDE INSTALLATION

Assemble AIR PORT™ as shown in figure 1. To install in left side of vehicle window channel (drivers side), roll down window, place AIR PORT™ as shown in figure 2, roll up window glass until it fits snugly in the base (part 1).

Adjust angle connector (part 2) and blade (part 3) to place air flow at desired flow angle. Position of blade on AIR PORT™ should be pointed outward and ahead, to channel air to desired location. Tighten screws (part 4) enough so that the blade doesn’t move (finger tight). Attach safety cord (part 5) to an interior anchor. Check tightness of screws periodically.
figure 2 Left Side Installation


figure 3 Right Side Installation

RIGHT SIDE INSTALLATION

To install on right side (passenger side) of car, remove screw that connects angle connector (part 2) to base (part 1). Flip over angle connector to other side of base and re-install screw and nut. Swivel blade right side up, install in window at desired location and adjust to desired angle of air flow.
Tighten screws (part 4) enough so that the blade doesn’t move (finger tight). Attach safety cord (part 5) to an interior anchor. Check tightness of screws periodically.


AIR PORT™ cold air vent is made out of a transparent, unbreakable poly carbonate. It is moulded and or shaped into the parts listed. These parts may break or crack if forcibly bent to other shapes or angles than the original ones of this product as sold by manufacturer.

The manufacturer and or distributor of AIR PORT™ assume no safety responsibilities of AIR PORT™ and or parts installed properly or improperly. The retail purchaser assumes all risks in the use of this product from time of purchase. AIR PORT™ or parts are not to be handled by children or pets as injury may occur.

Canadian Patent #: CA-110529
US Patent #: USD541199

AIR PORT™ Cold Air Vent Installed


Click to enlarge


Dealer and Wholesale Inquires Welcomed

Please contact at 1-506-276-3555 or email at sales@canadiangreenproducts.ca.

© 2007 Canadian Green Products. All Rights Reserved.